Filter
Top Products
Controlling the rest of your system
11
51
En
English
Français
Deutsch
Nederlands
Italiano
Español
Selecting preset codes directly
1 While pressing the RECEIVER button,
press the
SETUP
button.
The remote LCD display shows
SETUP
.
2 Use
/
to select PRESET then press
ENTER
.
3 Press the MULTI CONTROL button for the
component you want to control then press
ENTER
.
The LCD on the remote displays the
component you want to control.
1
4 Use
/
to select the first letter of the
brand name of your component then press
ENTER
.
This should be the manufacturer’s name (for
example,
P
for Pioneer).
5 Use
/
to select the manufacturer’s
name from the list then press
ENTER
.
6 Use
/
to select the proper code from
the list, then try using this remote control
with your component.
The code should start with the component type
(for example,
DVD 009
). If there is more than
one, start with the first one.
To try out the remote control, switch the
component on or off (into standby) by pressing
SOURCE
. If it doesn’t seem to work, select
the next code from the list (if there is one).
7 If your component is controlled
successfully, press
ENTER
to confirm.
The remote LCD display shows
OK
.
Programming signals from other
remote controls
If the preset code for your component is not
available, or the available preset codes do not
operate correctly, you can program signals
from the remote control of another
component. This can also be used to program
additional operations (buttons not covered in
the presets) after assigning a preset code.
1 While pressing the RECEIVER button,
press the
SETUP
button.
The remote LCD display shows
SETUP
.
2 Use
/
to select
LEARNING
then press
ENTER
.
3 Press the MULTI CONTROL button for the
component you want to control then press
ENTER
.
The LCD on the remote displays the
component you want to control.
2
PRES KEY
shows in the LCD display.
4 Point the two remote controls towards
each other then press the button that will be
doing the learning on this receiver’s remote
control.
PRES KEY
starts flashing to indicate the
remote is ready to accept a signal.
Note
1 You can’t assign the
RECEIVER
button.
ANALOG
AT T
SB ch
SLEEP
RECEIVER
SOURCE
SYSTEM OFF
INPUT
SELECT
TV DVR
TV CTRL
CD
RECEIVER
AMFM
DVD
CD-R/TAPE
USB
AV PRE-PROGRAMMED
AND LEARNING
REMOTE CONTROL UNIT
MIDNIGHT/
LOUDNESS
DIMMER
SR+
+10
D.ACCESS
DIALOG E
CLASS
DISC
ENTER
TV CONTROL
VOL
TUNE
TUNE
ST ST
INPUT
SELECT
TV CH
TV VOL
ENTER
TOP MENU
PTY SEARCH
T. EDIT
MENU
RETURN
GUIDE
SETUP
2• You can’t assign the
RECEIVER
button.
• TV CONTROL
buttons (
TV
,
TV VOL +/–
,
TV CH +/–
and
INPUT SELECT
) can only be learned after selecting
TV CONT
.
VSX_916.book.fm 51 ページ ２００５年１２月２２日 木曜日 午後４時２１分