Filter
Top Products
2 Press c or d to swtch RCA output set-
ting.
Pressing c or d will switch between
RCA:S/W (subwoofer) and RCA:NON (non
fading) and that status will be displayed.
Selecting the digital
attenuator
When listening to a CD or other source on
which the recording level is high, setting the
equalizer curve level to high may result in dis-
tortion. You can switch the digital attenuator
to low to reduce distortion.
! Sound quality is better at the high setting
so this setting is usually used.
1 Press FUNCTION to select DIG.ATT.
Press FUNCTION repeatedly until DIG.ATT ap-
pears in the display.
2 Press c or d to switch DIG.ATT high or
low.
Pressing c or d will switch between
DIG.ATT: H (high) and DIG.ATT: L (low) and
that status will be displayed.
# When the source isCassette player,the digital
attenuator setting isfixed at Low.
Adjusting display contrast
Display contrast adjustment lets you adjust
the display for easier viewing when lighting
conditions change.
1 Press FUNCTION to select CONTRAST.
Press FUNCTION repeatedly until CONTRAST
appears in the display.
2 Press c or d to adjust the contrast.
Each press of c or d increases or decreases
the contrast.
+7 7 is displayed as the contrast is in-
creased or decreased.
Switching the telephone
muting/attenuation
Sound from this system is muted or attenu-
ated automatically when a call is made or re-
ceived using a cellular telephone connected to
this unit.
! The sound turns off, MUTE or ATT is dis-
played and no audio adjustments, except
volume control, are possible.
! Operation returns to normal when the
phone call is ended.
1 Press FUNCTION to select MUTE.
Press FUNCTION repeatedly until MUTE ap-
pears in the display.
2 Press c or d to select the desired set-
ting.
Each press of c or d selects settings in the
following order:
MUTE (muting) 10dB ATT (attenuation)
20dB ATT (attenuation)
20dB ATT has a stronger effect than
10dB ATT.
Initial Settings
En
38
Section
10