Filter
Top Products
Introduction of audio
adjustments
21
3
1 SW indicator
Shows when the subwoofer output is turned
on.
2 LOUD indicator
Appears in the display when loudness is
turned on.
3 Audio display
Shows the audio adjustments status.
% Press AUDIO to display the audio func-
tion names.
Press AUDIO repeatedly to switch between
the following audio functions:
FADER (balance adjustment)LOUD (loud-
ness)SUB.W (subwoofer)80Hz (subwoo-
fer setting)SLP (subwoofer slope)F-HPF
(front high pass filter) R-HPF (rear high pass
filter)
# When the RCA outputsetting is RCA:NON,
SUB.W, 80Hz andSLP change to NonFAD (non
fading) function.
# When the front highpass filter is turned on,
you can select F-SLP (front high passfilter slope).
# When the rear highpass filter is turned on,
you can select R-SLP (rear high pass filterslope).
# Toreturn to the display of eachsource, press
BAND.
Note
If you do not operatethe audio function within
about 30 seconds,the display is automatically re-
turned to the sourcedisplay.
Using balance adjustment
You can select a fader/balance setting that
provides an ideal listening environment in all
occupied seats.
1 Press AUDIO to select FADER.
Press AUDIO until FADER appears in the dis-
play.
# If the balance settinghas been previously ad-
justed, BAL willbe displayed.
2 Press a or b to adjust front/rear speak-
er balance.
Each press of a or b moves the front/rear
speaker balance towards the front or the rear.
FADER:F25 FADER:R25 is displayed as the
front/rear speaker balance moves from front to
rear.
# FADER:0 is the proper settingwhen only two
speakers are used.
3 Press c or d to adjust left/right speaker
balance.
When you press c or d, BAL: 0 is displayed.
Each press of c or d moves the left/right
speaker balance towards the left or the right.
BAL:L25 BAL:R25 is displayed as the left/
right speaker balance moves from left to
right.
Audio Adjustments
En
28
Section
08