Filter
Top Products
Listening to the radio
1
3
2
These are the basic steps necessary to operate
the radio. More advanced tuner operation is
explained starting on the next page.
Important
If you are using thisunit in North, Central or
South America, resetthe AM tuning step (see
Setting the AM tuningstep on page 37).
1 Band indicator
Shows which band the radio is tuned to, AM
or FM.
2 Stereo (5) indicator
Shows that the frequency selected is being
broadcast in stereo.
3 Frequency indicator
Shows to which frequency the tuner is
tuned.
1 Press SOURCE upward or downward to
select the tuner.
Press SOURCE until you see Tuner displayed.
2 Use VOLUME to adjust the sound level.
Press VOLUME on the head unit upward to in-
crease the volume, and press downward to
lower the volume.
3 Press BAND to select a band.
Press BAND until the desired band is dis-
played, F1, F2, F3 for FM or AM.
4 To perform manual tuning, press c or
d with quick presses.
The frequencies move up or down step by
step.
5 To perform seek tuning, press and hold
c or d for about one second and release.
The tuner will scan the frequencies until a
broadcast strong enough for good reception is
found.
# You can cancelseek tuning by pressing either
c or d witha quick press.
# If you press and holdc or d you can skip
broadcasting stations. Seektuning starts as soon
as you release thebuttons.
Note
When the frequencyselected is being broadcast
in stereo the stereo(5) indicator will light.
Tuner
En
10
Section
04