Filter
Top Products
1 Press AUDIO to select the slope setting.
Press AUDIO until SLP appears in the display.
# When the subwooferoutput is on, you canse-
lect SLP.
2 Press c or d to select slope.
Press c and 12dB is displayed. Press d and
18dB is displayed.
Note
When slope of subwoofer and high passfilter are
12dB, and samecut-off frequency, the phaseis
reversed 180 degreesat the cut-off frequency. In
this case, reversingthe phase assures improved
sound continuity.
Using the high pass filter
When you do not want low sounds from the
subwoofer output frequency range to play
from the front or rear speakers, turn the HPF
(high pass filter) on. Only frequencies higher
than those in the selected range are output
from the front or rear speakers. You can set up
front and rear separately.
1 Press AUDIO to select F-HPF or R-HPF.
Press AUDIO until F-HPF or R-HPF appears in
the display.
2 Press a to turn high pass filter on.
F-HPF 80Hz or R-HPF 80Hz appears in the dis-
play. High pass filter is now on.
# Toturn high pass filter off, pressb.
3 Press c or d to select cut-off frequency.
Each press of c or d selects cut-off frequen-
cies in the following order:
506380100125 (Hz)
Only frequencies higher than those in the se-
lected range are output from the front or rear
speakers.
Adjusting high pass filter
attenuation slope
When the high pass filter is on, you can adjust
the continuity of sound between speaker
units.
1 Press AUDIO to select the slope setting.
Press AUDIO until F-SLP or R-SLP appears in
the display.
2 Press c or d to select slope.
Press c and 12dB is displayed. Press d and
6dB is displayed.
Using non fading output
When the non fading output setting is on, the
audio signal does not pass through this units
low pass filter (for the subwoofer), but is out-
put through the RCA output. For more details,
see Switching the RCA output setting on page
37.
1 Press AUDIO to select NonFAD.
Press AUDIO until NonFAD appears in the
display.
# When the RCA outputsetting is RCA:NON,
you can select NonFAD.
2 Press a to turn non fading output on.
NonFAD:ON appears in the display. Non fad-
ing output is now on.
# Toturn non fading output off, pressb.
Adjusting non fading output level
When the non fading output is on, you can ad-
just the level of non fading output.
Audio Adjustments
En
30
Section
08