Filter
Top Products
The System Setup menu
07
35
En
English
Français
Deutsch
Nederlands
Italiano
Español
3 Use
/
to select the channel you want,
using
/
to check the settings.
The MCACC channel EQ indicators in the front
panel display will light accordingly.
4 When you're finished, press RETURN.
You will return to the Manual MCACC setup menu.
Manual speaker setup
These settings optimize surround sound
performance (if you’re satisfied with the settings
made in
Using the Quick Setup
on page 7 or (
VSX-
516 only
)
Automatically setting up for surround
sound (MCACC)
on page 8, adjustment may not
be necessary). You only need to make these
settings once (unless you change the placement
of your current speaker system or add new
speakers).
1 Select SP SETUP from the System Setup
menu.
2 Use
/
to select the setting you want to
adjust then press
ENTER
.
•
SP SET
– Specify size / number of speakers
connected (see
Speaker setting
below).
•
X.OVER
– Specify which frequencies will
be sent to the subwoofer (see
Crossover
network
below).
•
CH LEVEL
– Adjust overall balance of your
speaker system (see
Channel level
below).
•
SP DISTN.
– Specify the distance of your
speakers from the listening position (see
Speaker Distance
below).
3 Press RETURN after making the
adjustments necessary for each setting.
Speaker setting
Use this setting to specify your speaker
configuration (size, number of speakers).
1 Select
SP SET
from the SP SETUP menu.
2 Use
/
to choose the speaker(s) that
you want to set then select a speaker size.
Use
/
to select the size (and number) of
each of the following speakers:
•
Front
(
F
) – Select
LARGE
if your front
speakers reproduce bass frequencies
effectively, or if you didn’t connect a
subwoofer. Select
SMALL
to send the bass
frequencies to the subwoofer.
1
•
Center
(
C
) – Select
LARGE
if your center
speaker reproduces bass frequencies
effectively, or select
SMALL
to send bass
frequencies to the other speakers or
subwoofer. If you didn’t connect a center
speaker, choose
NO
(the center channel is
sent to the front speakers).
•
Surround
(
S
) – Select
LARGE
if your
surround speakers reproduce bass
frequencies effectively. Select
SMALL
to
send bass frequencies to the other
speakers or subwoofer. If you didn’t
connect surround speakers choose
NO
(the sound of the surround channels is
sent to the front speakers or a subwoofer).
•
Surround Back
(
SB
) –
Select
LARGE
if your
surround back speaker reproduce bass
frequencies effectively. Select
SMALL
to
send bass frequencies to the other speakers
or subwoofer. If you didn’t connect
surround back speaker choose
NO
.
2
•
Subwoofer
(
SW
) – LFE signals and bass
frequencies of channels set to
SMALL are
output from the subwoofer when YES is
selected. Choose the PLUS setting if you
want the subwoofer to output bass sound
continuously or you want deeper bass (the
bass frequencies that would normally
Note
1 If you select SMALL for the front speakers the subwoofer is fixed to YES. Also, the center, surround, and surround back speak-
er can’t be set to LARGE if the front speakers are set to SMALL. In this case, all bass frequencies are sent to the subwoofer.
2• If the surround speakers are set to NO, the surround back speaker will automatically be set to NO.
• If you select one surround back speaker only, make sure that speaker is hooked up to the left surround back terminal.
VSX_516.fm 35 ページ ２００５年１２月２２日 木曜日 午後３時５０分