Filter
Top Products
Connecting up
04
15
En
English
Français
Deutsch
Nederlands
Italiano
Español
Connecting antennas
Connect the AM loop antenna and the FM wire
antenna as shown below. To improve reception
and sound quality, connect external antennas
(see
Using external antennas
below).
1 Pull off the protective shields of both AM
antenna wires.
2 Push open the tabs, then insert one wire
fully into each terminal, then release the tabs
to secure the AM antenna wires.
3 Fix the AM loop antenna to the attached
stand.
To fix the stand to the antenna, bend in the
direction indicated by the arrow (
fig. a
) then
clip the loop onto the stand (
fig. b
).
• If you plan to mount the AM antenna to a
wall or other surface, secure the stand with
screws (
fig. c
) before clipping the loop to
the stand. Make sure the reception is clear.
4 Place the AM antenna on a flat surface
and in a direction giving the best reception.
5 Connect the FM wire antenna in the same
way as the AM loop antenna.
For best results, extend the FM antenna fully
and fix to a wall or door frame. Don’t drape
loosely or leave coiled up.
Using external antennas
To improve FM reception
Use a PAL connector to connect an external
FM antenna.
To improve AM reception
Connect a 5 to 6 meter length of vinyl-coated
wire to the AM antenna terminal without
disconnecting the supplied AM loop antenna.
For the best possible reception, suspend
horizontally outdoors.
AM
LOOP
FM UNBAL
75
Ω
ANTENNA
3
1
2
4
5
fig. a fig. b fig. c
AM
LOOP
FM UNBAL
75
Ω
ANTENNA
One-touch
PAL connector
75 Ω coaxial cable
AM
LOOP
FM UNBAL
75
Ω
ANTENNA
Outdoor
antenna
Indoor antenna
(vinyl-coated wire)
5 to 6 meters
VSX_516.fm 15 ページ ２００５年１２月２２日 木曜日 午後３時５０分