Filter
Top Products
REFERENCES
26
RQTX1220
26
ENGLISH
ENGLISH
Picture Page
Auto zoom function does not
operate correctly.
• Switch off the zoom function of the TV.
• Use the other preset aspect ratios or manual adjustment.
• Zoom function does not work well especially in dark scenes or does not work at all due to
the type of disc.
–
20
–
When playing PAL disc, picture is
distorted.
• Set “TRANSFER MODE” in Menu 2 to “AUTO”. 13
Progressive video Page
There is a ghosting effect when the
progressive output is on.
• Set “VIDEO OUT (I/P)” in “VIDEO” menu to “INTERLACE”. 20
Picture not in progressive output. • Set “VIDEO OUT (I/P)” in “VIDEO” menu to “PROGRESSIVE”.
• If you connect the system to the TV through the VIDEO OUT terminal, output will be
interlace, even if “PRG” is shown.
20
–
Radio Page
Distorted sound or noise is heard.
“ST” flickers or does not show.
• Adjust the position of the FM or AM antenna.
• Press [PLAY MODE] to select “MONO”.
6, 7
16
A beat sound is heard. • Switch off the TV or move it away from the system. –
A low hum is heard during AM
broadcasts.
• Move the antenna away from other cables and cords.
• Set to “BP 1” or “BP 2”.
–
16
USB Page
The USB mass storage device or
the contents in it cannot be read.
• The format of the USB mass storage device or the contents in it is/are not compatible
with the system.
• USB mass storage devices with storage capacity of more than 32 GB cannot work in
some conditions.
14
–
Slow operation of the USB mass
storage device.
• Large content size or large memory USB mass storage device takes longer time to read
and show on the TV.
–
USB recording stops suddenly
“REC ERROR”.
• Error occurred during USB recording. Disconnect the USB mass storage device and then
connect again.
14
Cassette tape Page
Unsatisfactory sound quality. • Clean the heads. Below
Recording is not possible. • If the erasure prevention tabs have been removed, put adhesive tape across the holes. 16
The tape is stuck.
Cannot eject the cassette tape.
• Close the cassette tape deck. Switch off the system and then switch it on again. Press
[
8
/
x
, STOP/EJECT] again.
16
Memory reset (Initialisation)
When these situations occur, refer to the instructions below to reset the memory:
• There is no response when buttons are pressed.
• You want to clear and reset the memory contents.
To reset memory
1. Disconnect the AC mains lead. (Wait 3 minutes before you continue with step 2.)
2. While you press and hold [
1
] on the main unit, connect the AC mains lead again.
“- - - - - - - -” shows on the display panel.
3. Release [
1
].
All the settings are set back to the factory preset. It is necessary to set the memory items again.
Maintenance
To clean this system, wipe with a soft, dry cloth.
• Never use alcohol, paint thinner or benzine to clean this system.
• Before using chemically treated cloth, read the instructions that came with the cloth carefully.
For a good quality sound (cassette tape deck)
Clean the heads regularly to make sure that you get good quality playback and recording. Use a cleaning tape (not included).
VKX80_GC_1En.indd 26VKX80_GC_1En.indd 26 9/22/2010 2:34:47 PM9/22/2010 2:34:47 PM