49
RQT7388
Use one of the following connections to suit the antenna lead.
∫ A single twin lead
≥If your television has both lead and coaxial VHF terminals, use the
lead connection to minimize signal loss.
∫ A twin lead and a coaxial cable
∫ Two twin leads
Use one of the following connections to suit the antenna terminals
on your television. Refer to the television’s operating instructions.
∫ A twin lead and coaxial plug terminal
∫ A twin lead terminal
∫ Two twin lead terminals
∫ Multiple antenna terminals
≥Connect to one of the ANTterminals, then change the television’s
setting as necessary.
If the antenna connector doesn’t match
Other antenna connections to the unit
300–75 ≠ transformer
(not included)
from the antenna
(Flat) Twin lead 300 ≠ cable
To this unit’s
RF IN terminal
from the antenna
(Flat) Twin lead
300 ≠ cable
To this unit’s
RF IN terminal
(Round)
75 ≠ coaxial cable
VHF/UHF band mixer
(not included)
from the antenna
To this unit’s
RF IN terminal
300–75 ≠ transformer
(not included)
(Flat) Twin lead
300 ≠ cable
VHF/UHF band mixer
(not included)
Other antenna connections from the unit to the
television
VHF/UHF band separator
(not included)
Television
75 ≠ coaxial cable
VHF
UHF
75 ≠ coaxial cable
75–300 ≠ transformer
(not included)
Television
VHF or
UHF
75 ≠ coaxial cable
VHF/UHF band separator
(not included)
Television
VHF
UHF
ANT 2
ANT 1
Split out
Television
75 ≠ coaxial cable
7388en.book 49 ページ 2003年12月22日 月曜日 午後9時39分