Panasonic SC-HT820V Speaker System User Manual


 
42
RQT7388
The radio
Press [TUNER] to put the remote control in TUNER mode.
Up to 15 stations can each be set in the FM and AM bands.
1 Press [FM/AM] to select “FM”.
2 Press [6] or [5] to tune to the
lowest frequency (“FM 87.9” MHz or
“FM 87.5” MHz).
3 Press and hold [ENTER].
Release the button when “FM AUTO” is displayed.
The tuner presets all the stations it can receive into the
channels in ascending order.
“SET OK” is displayed when the stations are set. The last
station to be set is then played.
4 Repeat steps 1 to 3 to set the AM
bands.
1 Press [FM/AM] to select “FM” or “AM”.
2 Press the numbered buttons to select
the channel.
Alternatively, press [W CH] or [X CH].
To select a 2-digit number
e.g. 12: [S10] [1] [2].
When a stereo FM broadcast is being received.
If noise is excessive in FM
Press [PLAY MODE] to display “MONO”.
Press [PLAY MODE] again to cancel the
mode.
The mode is also canceled when you
change the frequency.
1 Press [FM/AM] to select “FM” or
“AM”.
2 Press [6] or [5] to select the
frequency.
Press and hold [6] or [5] until the frequency starts
scrolling to start automatic tuning. Tuning stops when a station
is found.
1 Tune to the station (left).
2 Press [ENTER].
3 While “PGM” is flashing on the display
Press the numbered buttons to select
a channel.
Alternatively, press [W CH] or [X CH] then press [ENTER].
The station occupying a channel is erased if an2.9178J-17.4361 -7.39850py