39
RQT7388
The unit tunes automatically after you plug it in and turn it on for the first time (➜ page 15, Plug-in Auto Tuning), but you can start the process
again if necessary.
≥Make sure you have tuned to a television channel. This does not work if you have selected “AU” channel.
1 Press [34] to select “CHANNEL SET” and press [ENTER].
2 Press [34] to select “ANTENNA
SYSTEM” and press [ENTER].
3 Press [34] to select “TV” or “CATV”
to suit the type of antenna you are
using.
Channels are set corresponding to the antenna system you select.
This is set automatically when you do Plug-in Auto Tuning.
To exit the settings screen
Press [MENU] until the screen disappears.
Auto tuning searches for TV stations and memorizes every tuned
program position. Other program positions are skipped. (Channel
range ➜ right)
2 Press [34] to select “AUTO” and
press [ENTER].
Auto tuning starts. It takes three or more minutes to complete.
To stop partway through
Press [MENU].
You can manually preset channels that are skipped when using the
auto channel setting, and manually skip channels that are preset.
2 Press [34] to select “MANUAL” and
press [ENTER].
3 Press [34] to select “CH” and [21]
to select the channel.
4 Press [34] to select “BLANK” and
[21] to select “ON” or “OFF”.
To exit the settings screen
Press [MENU] until the screen disappears.
∫ Channel range
≥TV mode
≥CATV mode
CHANNEL SET
ANTENNA SYSTEM
AUTO
ANTENNA SYSTEM
≥
TV
CATV
SELECT: :
END :MENU
34
AUTO CHANNEL SET
PROCEEDING
END :MENU
2
MANUAL
Band Airwaves
VHF 2–13
UHF 14–69
Band Cable
VHF 2–13
CATV LOW BAND 95–99
CATV MID/SUPER BAND 14–36
CATV HYPER BAND 37–65
ULTRA BAND
66–94
100–125
SPECIAL CATV CHANNEL 1
MANUAL CHANNEL SET
CH
BLANK
SELECT
END :MENU
2
ON OFF
: s/r:
34 21
¥
[Remember] Press [VHS] first.
7388en.book 39 ページ 2003年12月22日 月曜日 午後9時39分