Filter
Top Products
14
After connecting the external devices, do the following procedures:
• Mode setting
• Input signal assignment to the SUB OUTPUT jack
• Output signal assignment to the LINE IN jack, MULTI INPUT ST jacks, or MULTI INPUT MONO connector.
■ Unit Modes and Signal Flow
This unit has three modes. Set the suitable mode with DIP switch for the desired broadcasting system.
● Mode 1
Stereo or monaural amplification are applicable in Mode 1.
The stereo and mono input signals are mixed for output.
Stereo amplification
After the signals from stereo and mono input lines are mixed, they are output through the STEREO OUT jack toward one
zone.
Output jack(s) connecting the amplifier or speakers determine(s) the output line.
The mode is determined with Switch A and B of the DIP switches. (Refer to the next page.)
Signal Flow
To adjust the output levels
Mono and stereo outputs are individually adjustable.
In the case shown in the figure, the volume of microphones is adjusted with the MONO OUT knob and that of stereo source
devices is adjusted with the STEREO OUT knob.
4
28
100
1
6
4
28
100
2
6
4
28
100
3
6
4
28
100
4
6
MONO
POWER
4
28
100
1
6
4
28
100
2
6
4
28
100
3
6
4
28
100
4
6
4
4
2
2
8
8
100
100
6
6
ST
MULTI IN
4
28
100
6
SUB OUT
STEREO
MONO
STEREO OUT
INPUT
REAK
LINE IN
SUB
4
2
8
100
6
MONO OUT
Audio Mixer WR-XS3
Speakers
MD
CD TAPE
Any output can be assigned.
Both mono and stereo inputs
are available.
Any mono and stereo
input can be assigned to
the SUB OUTPUT jack.
MONO
INPUT 1 to 4
STEREO
INPUT 1 to 4
MULTI IN
(MONO/
STEREO)
STEREO
OUTPUT
Digital Multi Equalizer
Power amplifier
Video
sound
Internal MIX
Microphone
on the platform
Microphone
for a host
Antenna for
wireless microphone
Wireless
microphone
Diversity wireless receiver
Wireless microphone
in the hall
SETUP PROCEDURES