Filter
Top Products
10
Input level: –10 dBV
Impedance: 10 kΩ
o Multiple mono input connector [
MULTI INPUT MONO
]
Connects a microphone. When using this connector,
remove the short pin.
Mono: 1 circuit
Input connector: XLR-3-31 type balanced
Input level: –45 dB
Impedance: 10 kΩ
!0 Stereo input jacks [STEREO INPUT L/R 1 - 4]
These XRL connectors receive input signals from up to
4 audio-visual devices such as a CD player and tape
recorder.
Stereo: 4 circuits
Input jack: PIN jack unbalanced
Input level: –10 dBV
Impedance: 10 kΩ
!1 Mono input connectors [MONO INPUT 1 - 4]
These XLR connectors receive input signals from up to
4 microphones or other input devices.
Mono: 4 circuits
Input connector: XLR-3-31 type balanced
Input level: –10 dB to –60 dB
Impedance: 10 kΩ
!2 AC inlet socket [AC IN]
To use the unit, plug the power cord (supplied as a
standard accessory) into this socket and connect it to
an AC receptacle.
!3 Grounding screw [SIGNAL GND]
Notes:
• An RCA type pin plug cable is recommended for con-
nection between the unit and a CD player through the
MULTI INPUT ST jacks or the STEREO INPUT 1 - 4
jacks. Use RCA type pin jacks to connect external
devices when the devices have both of RCA and XLR
type pin jacks.
• When using a condenser microphone, connect it to an
external device.
• Do not connect external devices supplying phantom
power, as it may damage the unit.