Filter
Top Products
42
STANDBY/ON
STANDBY
DVD
ZONE 2
()
GRN
REC
()
RED
AUDIO
SELECTOR
PURE AUDIOUPSAMPLING
OFF
ON
POWER
MASTER VOLUME
TUNER
PHONO
NET AUDIOC
D
TAPE
VIDEO
3
VIDEO
5
VIDEO
4
VIDEO
2
VIDEO
1
VCR
2
VCR
1
DISPL
AY
STEREOSURROUND
THX DSPREC OUTZONE 2 OFF RT/
PTY/
TP
MEMORYFM MODE
SETUP
ENTER
RETURN
S VIDEO AUDIO
VIDEO L R
DIGITAL
VIDEO 5 INPUT
PRESET
TUNINGCLEAR
ZONE 2 LEVEL
PHONES
OFF
ZONE 2
ZONE 2 LEVEL
/
Enjoying music or videos in the remote zone
Using the buttons on the TX-NR900/900E
1. Press the ZONE 2 button on the TX-NR900/900E.
2. Select an input source.
After pressing the ZONE 2 button, you must press an input
source button within 8 seconds. The indicator above the input
source button lights green. In this condition, even if you change
the input source for the main zone, the input source for the
remote zone (Zone 2) will not change.
Ex.: When the CD button is pressed.
To select the same source for the remote zone that is selected
for the main zone, press the ZONE 2 button again until
“Zone2Sel:SOURCE” appears in the display. In this condition,
if you change the input source for the main zone, the input source
for the remote zone (Zone 2) will change as well.
When “Zone2Sel:Off” is displayed, the output to the remote
zone is turned off.
ZONE 2 indicator
Input source buttons
Notes:
• If a sleep time is set with the SLEEP button, the output to the
remote zone will also turn off when the sleep time elapses.
• The ZONE 2 terminal is an analog output. Digital signals are not
output. If no sound is heard from the selected input source, check
if the component is connected to the analog inputs.
• If the REC OUT button is pressed in the main room while
someone is using the system in the remote zone, the Zone 2
function will be deactivated and the source will turn off in the
remote zone.
• If you select FM (or AM) with the TUNER input source buttons
when the source for the remote zone (Zone 2) is set to AM (or
FM), the output for the remote zone also changes to AM (or FM).
• 7.1-channel playback in the main room is disabled if the Surr
Back/Zone 2 setting in the Surr Back/Zone 2 sub-menu of the
Hardware Setup Menu is set to “Zone 2.”
• When you are using the remote zone (Zone 2),
system
operation will not work.
• When you are using the remote zone (Zone 2), the Pure Audio
setting will not work.
• When you are not using the remote zone (Zone 2), press the
ZONE 2 button and then press the OFF button to turn off
the ZONE 2 indicator. (Using the remote controller, press
the ZONE 2 button and then the STANDBY button.)