Filter
Top Products
15
Turning On and Listening to AM and FM Radio
With this function, you can adjust the brightness of the
display.
Tuning into weak stereo FM stations
If the signal from a stereo FM station is weak, it may be
impossible to get good reception. In this case, switch to
Manual Tuning mode and listen to the station in mono.
Turning On the T-4555
1
Connect the power cord to a suit-
able wall outlet.
2
Press the [STANDBY/ON] button
on the T-4555 or remote control-
ler.
The T-4555 turns on, and the
STANDBY indicator goes off.
To turn off the T-4555, press the
[STANDBY/ON] button. The T-4555
will enter Standby mode.
Note that the T-4555 is not completely
shutdown in Standby mode.
Setting the Display Brightness
Press the remote controller’s
[DIMMER] button repeatedly to
select: dim, dimmer, or normal
brightness.
STANDBY/ON
STANDBY/ON
TUNING/CH
BAND
TUNING MODE
TUNING/CH
TUNING MODE
DIMMER
BAND
/
STANDBY indicator
Remote controller
Remote controller
Listening to AM and FM Radio
1
Press the [BAND] button repeat-
edly to select AM or FM.
The or indicator lights up.
2
Press the [TUNING MODE] but-
ton repeatedly to select Auto or
Manual Tuning mode.
•Auto Tuning Mode
The AUTO indicator appears and
stereo radio reception is possible.
• Manual Tuning Mode
The MONO indicator appears and
radio reception will be in mono.
3
Use the TUNING/CH [ ]/[ ] but-
tons to tune into a station.
In Auto Tuning mode, once a station is
found, tuning stops automatically.
This model changes FM frequency in
0.05 MHz steps, 9 kHz steps for AM.
In Manual Tuning mode, the frequency
stops changing when you release the
buttons. Press the buttons repeatedly to
change the frequency one step at a
time.
When tuned into a station, the
TUNED indicator appears.
Remote controller
Remote controller
AUTO indicator
MONO indicator
Remote controller
TUNED