Filter
Top Products
110
Zone 2 and Zone 3
—Continued
Zone 3 speakers must be connected to an amp in Zone 3.
Connecting Your Zone 3 Speakers
You can enjoy 2-channel stereo playback in Zone 3 and
a different source to those selected for your main room
and Zone 2.
Hookup
• Use an RCA audio cable to connect the AV control-
ler’s ZONE 3 PRE OUT L/R jacks to an analog audio
input on your Zone 3 amp.
• Use an RCA audio cable to connect the AV control-
ler’s ZONE 3 PRE OUT SW jack to the line input on
a powered subwoofer in Zone 3.
• Connect your Zone 3 speakers to the speaker termi-
nals on your Zone 3 amp.
Note:
•With the default settings, the Zone 3 volume must be
set on the Zone 3 amp. If your Zone 3 amp has no vol-
ume control, set the Zone 3 Out setting to Variable so
that you can set the Zone 3 volume on the AV control-
ler (see page 110).
If you’ve connected your Zone 2 or Zone 3 speakers to
an amp with no volume control, set the Zone 2 Out or
Zone 3 Out setting, respectively, to Variable so that you
can set the zone’s volume, balance, and tone on the AV
controller.
Connecting Zone 3
R
L
IN
LINE INPUT
ZONE 3
PRE OUT
L
R
SW
Main room
Zone 3
Receiver/
integrated amp
AV controller
Powered
subwoofer
Multichannel power amp
Zone 2/Zone 3 Out Settings
1
Press the [RECEIVER] REMOTE
MODE button, followed by the
[SETUP] button.
The main menu appears onscreen.
2
Use the Up and Down [ ]/[ ]
buttons to select “7. Hardware
Setup,” and then press [ENTER].
The Hardware Setup menu appears.
3
Use the Up and Down [ ]/[ ]
buttons to select “2. Zone 2/
Zone 3,” and then press [ENTER].
The Zone 2/Zone 3 screen appears.
4
Use the Up and Down [ ]/[ ]
buttons to select “Zone 2 Out” or
“Zone 3 Out,” and use the Left
and Right [ ]/[ ] buttons to
select:
Fixed:
The Zone 2 or Zone 3 volume
must be set on the amp in that
zone.
Variable:
The Zone 2 or Zone 3 vol-
ume can be set on the AV con-
troller.
RECEIVER
S
E
T
U
P
ENTER
ENTER
ENTER
ENTER
7-2.Zone2/Zone3
Zone2 Out Fixed
Zone3 Out Fixed
ENTER
ENTER