Filter
Top Products
15
Step 3:
Playing Back
6
Using the multi-zone function
You can multi-zone connect the unit with an integrated
amplifier and speakers in a separate room and play sound
from an external device connected to the analog audio
input jacks of the unit, sound from the "NET", "USB" or
"BLUETOOTH" source, and the AM/FM broadcasting. It
is possible to perform playback in the main room and a
separate room at the same time, for example by playing
the Blu-ray Disc player in the main room where the unit is
placed while playing Internet radio in a separate room. It is
also possible to perform playback only in a separate room.
As for analog audio input, it is possible to play the
same source or different sources in the main room and
separate room.
As for the "NET", "USB" and "BLUETOOTH", you cannot
select different inputs for the main room and separate
room. For example, if "NET" has been selected in the
main room and then "USB" is selected as playback
source in the separate room, the input in the main room
will change to "USB" accordingly.
When listening to AM/FM broadcasting, you cannot
select different stations for the main room and separate
room. Therefore broadcasting of the same station will be
heard in the both rooms.
Connecting with Player
To output audio of the Blu-ray Disc player or such other
player as the source of multi-zone playback, it is necessary
to connect the RCA audio output jacks of the player and the
analog audio input jacks of the unit using the RCA cable.
AUDIO
OUT
Output to multi-zone is not possible if the connection is
only with HDMI cable or digital cable.
Some players require analog audio output setting.
Making multi-zone Connection
Connecting an amplifier or receiver in another
room
It is possible to play 2 channel source in a separate room
while 7.2 channel source is being played in the main room.
Connect the LINE OUT ZONE2 jacks of the unit and the
line-in jacks of the integrated amplifier in a separate room
with an RCA cable.
Zone 2
The volume should be adjusted with the integrated
amplifier used in the separate room.
Connecting speakers in another room
It is possible to directly connect the speakers in another
room without an amplifier. Connect the speakers in another
room to the SPEAKERS ZONE2 speaker terminals of
the unit using speaker cables. Note that 5.2 ch will be the
maximum (
¼
) in the main room during Zone 2 playback. No
sound will be output from the Surround Back speakers and
Height speakers.
¼
In this case, some listening modes including Dolby Atmos cannot be
selected.
Zone 2
Change the setting: After connecting the speakers, press
RCV and then HOME on the remote controller, select
"Setup" - "2. Speaker Setup" - "Speaker Settings" and set
"Powered Zone2" to "Yes".
Adjust the volume on this unit. To adjust the volume,
press ZONE2
on the remote controller and adjust with
VOL
S
/
T
.
To control on the main unit, press ZONE2 and
within 8 seconds, adjust with the MASTER VOLUME
control. You can mute the sound by pressing MUTING on
the remote controller.