Filter
Top Products
33
Common Functions—Continued
With this function you can adjust the brightness of the dis-
play.
With this function you can adjust the volume level of each
individual speaker as you like. Unlike the individual speaker
volume settings described on page 27, these adjustments can
be carried out while listening to your favorite music, and they
are temporary (i.e., they are not saved when the HT-R510 is
set to Standby), although you can save them if you want.
To cancel this function, press the [CH SEL] button repeat-
edly until the previous display appears.
To save your adjustments, updating the settings described on
page 27, press the [TEST] button.
Notes:
•You cannot use this function while the HT-R510 is muted (see
page 32).
• Only speakers that are included in the current configuration can
be adjusted. See “Specifying the Number of Speakers” on
page 25.
• The subwoofer cannot be selected if the subwoofer mode is set to
“Subwoofer Off” (page 25).
With the sleep timer you can set the HT-R510 so that it auto-
matically turns off after a set period.
You can connect a pair of stereo headphones (1/4-inch phone
plug) to the HT-R510’s PHONES jack for private listening,
as shown.
Notes:
•Always turn down the volume before connecting your
headphones.
• Speaker sets A and B are turned off while the headphones
plug is inserted in the PHONES jack.
• When you connect a pair of headphones to the HT-R510,
the listening mode is set to Stereo, unless it’s already set to
Stereo or Direct. When you disconnect the headphones, the
previous listening mode is selected.
• When you use the multi-channel inputs, only the front-left
and front-right channels can be heard in the headphones.
Setting the Display Brightness
Use the [DIMMER] button to select:
dim, dimmer, or normal brightness.
Adjusting the Speaker Balance
Temporarily
1
Use the remote controller’s
[CH SEL] button to select each
speaker, and use the LEVEL [ ] [ ]
buttons to adjust the volume.
Speakers are selected in the following
order: Left → Center → Right → Surr
Right → Surr Back → Surr Left → Sub-
woofer.
You can adjust the volume of each
speaker from –12 dB to +12 dB.
The name of the currently selected
speaker and its volume appear on the dis-
play, as shown.
DIMMER
Remote controller
Using the Sleep Timer
(remote controller only)
Press the [SLEEP] button repeat-
edly to select the required sleep
time.
You can set the sleep time from 90 to 10
minutes in 10 minute steps.
The SLEEP indicator appears on the dis-
play when the sleep timer has been set, as
shown. The specified sleep time appears
on the display for about five seconds, then
the previous display reappears.
To cancel the sleep timer, press the
[SLEEP] button repeatedly until the
SLEEP indicator disappears.
To check the remaining sleep time,
press the [SLEEP] button. Note that if you
press the [SLEEP] button while the sleep
time is being displayed, you’ll shorten the
sleep time by 10 minutes.
Using Headphones
Remote controller
SLEEP indicator