53
First Time Setup—Continued
Note:
This procedure can also be performed on the AV receiver
by using its [SETUP] button, arrow buttons, and
[ENTER] button.
If you connect an -capable Onkyo MiniDisc
recorder, CD recorder, or RI Dock to the TV/TAPE IN/
OUT jacks, or connect an RI Dock to the GAME IN or
VCR/DVR IN jacks, for to work properly, you must
change this setting.
This setting can only be changed on the AV receiver.
Notes:
• DOCK can be selected for the TV/TAPE or GAME or
VCR/DVR input selector, but not at the same time.
• Enter the appropriate remote control code before
using the AV receiver’s remote controller for the first
time (see page 125).
3
Use the Up and Down [ ]/[ ] but-
tons to select “3. Tuner”, and
then press [ENTER].
The “Tuner” menu appears.
(North American and Taiwan models)
(TX-NR807)
(European, Australian and Asian
models)
4
Use the Left and Right [ ]/[ ]
buttons to select:
(North American and Taiwan models)
200kHz/10kHz:
Select if 200 kHz/10 kHz steps are
used in your area.
50kHz/9kHz:
Select if 50 kHz/9 kHz steps are
used in your area.
(European, Australian and Asian
models)
10kHz: Select if 10 kHz steps are
used in your area.
9kHz: Select if 9 kHz steps are used
in your area.
5
Press the [SETUP] button.
The setup menu closes.
Changing the Input Display
7–3. Tuner
FM/AM Frequency Step
SAT Radio Mode
200kHz/10kHz
None
AM Frequency Step 9kHz
7–3. Tuner
1
Press the [TV/TAPE], [GAME] or
[VCR/DVR] input selector button
so that “TV/TAPE”, “GAME” or
“VCR/DVR” appears on the dis-
play.
2
Press and hold down the [TV/
TAPE], [GAME] or [VCR/DVR]
input selector button (about 3
seconds) to change the setting.
Repeat this step to select MD, CDR, or
DOCK.
For the TV/TAPE input selector, the
setting changes in this order:
For the GAME input selector, the
setting changes in this order:
GAME ↔ DOCK
For the VCR/DVR input selector, the
setting changes in this order:
VCR/DVR
↔ DOCK
GAME TV/TAPE
VCR/DVR
or
or
or
or
(3 seconds)
TV/TAPE → MD → CDR
DOCK
→
→
TX-NR807_En.book Page 53 Tuesday, July 28, 2009 12:00 PM