Filter
Top Products
103
Advanced Setup—Continued
With this preference, you can protect your settings by
locking the setup menus.
Note:
This procedure can also be performed on the AV receiver
by using its [SETUP] button, arrow buttons, and
[ENTER] button.
The digital input signal formats are available only for the
input sources that you have assigned a digital input jack
(see page 50).
Normally, the AV receiver detects the signal format auto-
matically. However, if you experience either of the fol-
lowing issues when playing PCM or DTS material, you
can manually set the signal format to PCM or DTS:
• If the beginnings of tracks from a PCM source are cut
off, try setting the format to PCM.
• If noise is produced when fast forwarding or reversing
a DTS CD, try setting the format to DTS.
• The setting is stored individually for each input selec-
tor.
Lock Setup
1
Press the [RECEIVER] button followed by
the [SETUP] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make sure the
appropriate external input is selected on your TV.
2
Use the Up and Down [ ]/[ ] buttons to
select “9. Lock Setup”, and then press
[ENTER].
The “Lock Setup” menu appears.
3
Use the Left and Right [ ]/[ ] buttons to
select:
When the setup menus are locked, you cannot
change any setting.
Locked:
Setup menus locked.
Unlocked:
Setup menus not locked.
4
Press the [SETUP] button.
The setup menu closes.
9. Lock Setup
Lock Unlocked
Digital Input Signal Formats
1
Press the [RECEIVER] button, and then
press and hold [AUDIO] button for about
8 seconds.
2
While “Auto” is displayed (about 3 sec-
onds), press the Left and Right [ ]/[ ]
buttons to select: PCM, DTS or Auto.
PCM:
Only 2-channel PCM format input signals will be
heard. If the input signal is not PCM, the PCM
indicator will flash and noise may also be pro-
duced.
DTS:
Only DTS (but not DTS-HD) format input sig-
nals will be heard. If the input signal is not DTS,
the DTS indicator will flash and there will be no
sound.
Auto (default):
The format is detected automatically. If no digital
input signal is present, the corresponding analog
input is used instead.
TX-NR807_En.book Page 103 Tuesday, July 28, 2009 12:00 PM