Filter
Top Products
102
Advanced Setup—Continued
Power Control On: Power Control enabled.
Off: Power Control disabled.
To link the power functions of -compatible components connected via HDMI, select “On”.
This setting is set to “On” automatically when the above “HDMI Control (RIHD)” is set to “On” for the first
time.
Notes:
• The
“Power Control” setting can be set only when the above “HDMI Control (RIHD)” setting is set to “On”.
• HDMI power control only works with -compatible components that support it and may not work
properly with some components due to their settings or compatibility.
• When set to “On”, the power consumption on standby mode increases.
• When set to “On”, regardless of whether the AV receiver is On or on Standby, both audio and video received
by an HDMI input will be output by the HDMI OUT for playback on the TV or other component that’s
connected to the HDMI OUT.
• Refer to the connected component’s instruction manual for details.
TV Control On: TV Control enabled.
Off: TV Control disabled.
Set to “On” when you want to control the AV receiver from an -compatible TV that is connected to
HDMI.
Notes:
• Do not assign the component connected with the HDMI input to the TV/TAPE selector when you set “TV
Control” setting to “On”. Otherwise, appropriate CEC (Consumer Electronics Control) operation is not guar-
anteed.
•Set to
“Off” when the TV is not compatible or when it is unclear whether the TV is compatible or not.
• The
“TV Control” setting can be set only when the above “HDMI Control (RIHD)” and “Power Control”
settings are both set to “On”.
• Refer to the connected component’s instruction manual for details.
Network
See “Network Settings” on page 113.
Firmware Update
Notes:
• Perform the firmware update only when an announcement is posted on the Onkyo Web site.
• It takes about 40 minutes to complete the firmware update.
Version
The current version of the firmware is displayed. The version is made up of the versions of the AV receiver and
Onkyo dock (if connected).
Receiver via NET
You can update the AV receiver’s firmware. Check the network connection before update.
Do not shutdown the power of the AV receiver while update.
Universal Port via NET
You can update the Onkyo dock’s firmware. Check the network connection before update. Do not shutdown the
power of the AV receiver while update.
Note:
• This update shall not be performed when no dock is connected to UNIVERSAL PORT jack.
Note:
After changing the settings of the “HDMI Control (RIHD)”, “Power Control”, or “TV Control”, set all con-
nected pieces of equipment to Standby and then turn them on again. Refer to the User’s Manuals for all
connected pieces of equipment.
TX-NR807_En.book Page 102 Tuesday, July 28, 2009 12:00 PM