Filter
Top Products
9
CHAPTER 2
percent above the minimum amperage is recommended to
prevent peak voltage drops at the service entry.
CAUTION: In the unlikely event that the cir-
cuit breakers on the user panel trip (the white
center buttons pop out), disconnect the AC power
cable. Do not reset the breakers with the AC con-
nected. Contact Meyer Sound for repair information.
POWER CONNECTOR WIRING CONVENTIONS
The MILO 120 loudspeaker requires a grounded outlet. It
is very important that the system be properly grounded in
order to operate safely and properly. Figures 2.2, 2.3, and
2.4 illustrate correct wiring for the creation of power cables
and distribution systems.
Figure 2.2. MILO 120 user rear panel with L6-20 power connector
neutral (blue)
line (brown)
ground (green/yellow)
Figure 2.3. IEC 309 power connector pin-out
line (brown)
ground (green/yellow)
neutral (blue)
Figure 2.4. VEAM multi-pin connector power pin-out
If your MILO 120 loudspeaker is fitted with the VEAM multi-
pin connector, see the Meyer Sound document VEAM Cable
Wiring Reference (part number 06.033.113) for the wiring
conventions and pin-outs for AC, audio, and RMS connec-
tions.
Meyer Sound offers the VIM-3 (VEAM interface module) to
distribute power, audio, and RMS to MILO 120 loudspeak-
ers fitted with VEAM connectors, as shown in Figure 2.5.
Figure 2.5. VIM-3 module, front (top) and rear (bottom)