Filter
Top Products
4
CHAPTER 1
In addition, by integrating Meyer Sound M3D-Sub di-
rectional subwoofers (Figure 1.4) with a MILO/MILO-120
system (MILO, MILO 120 and M3D/M3D-Sub cabinets are
identical in width), you can easily augment bass power with
real depth while extending low-frequency bandwidth and
headroom.
Figure 1.4. The MILO 120 integrates easily with M3D-Sub subwoofers.
Since the M3D-Sub employs Meyer Sound’s proprietary
low-frequency directional control, you can configure arrays
that steer bass energy away from the area behind the array.
In applications where M3D-Sub features like directional low-
frequency control are not needed, a MILO/MILO 120 array
can be deployed in combination with Meyer Sound 700-
HP ultrahigh-power subwoofers. The 700-HP subwoofer
extends the MILO/MILO 120 system frequency response
down to 30 Hz.
NOTE: MILO 120 can also be used with
other Meyer Sound subwoofers, including
the 650-P high-power subwoofer.
RIGGING AND TRANSPORT
MILO 120’s QuickFly rigging employs rugged, reliable and
user-friendly components that remain captive in transit.
Custom front and rear AlignaLinks at the cabinet corners
couple the units for flying or stacking, and allow from 13 to
19 degrees of cabinet splay adjustable in two-degree incre-
ments.
NOTE: Optimal acoustical performance for
MILO 120 loudspeakers is achieved by using
angles between 13 and 19 degrees between cabi-
nets; avoid using angles outside this range.
Because rigging connections are rigid, array tilt is easy to
adjust – often eliminating the need for a pullback strap in
flown configurations. If circumstances dictate an acute
array curve, then a PBF-MILO pull back frame can be at-
tached to the lowest cabinet. The MG-3D/M multipurpose
grid accommodates multiple hanging configurations for
up to 24 MILO/MILO 120 loudspeakers (or the equivalent
weight of MILO, MILO 120, M3D, M3D-Sub or any other
relevant combination). The MG-3D/M grid allows multipoint
support and bridles and ground stacks of up to five MILO
120 cabinets and corresponding MILO 120-I inserts.
MILO 120 is truck-smart: Its exterior cabinet dimensions are
ideal for both European and US truck widths, while its
AlignaLinks are fully compatible with the optional MCF-
MILO caster frame — allowing you to transport stacks of
MILO 120, with or without the MILO 120-I insert, and facili-
tating the use of forklifts.
NOTE: Rigging accessories for MILO 120
are the same as for MILO and are illustrated
in Meyer Sounds MG-3D/M Assembly Guide (PN
05.132.036.01).