Filter
Top Products
iv
v
DECLARATION OF CONFORMITY ACCORDING TO ISO/IEC GUIDE 22 AND EN 45014
The manufacturer:
Meyer Sound Laboratories Inc.
2832 San Pablo Avenue
Berkeley, California 94702-2204, USA
Declares that the products: M3D™ and M3D-Sub conform to the
following product specications:
Safety: EN60065: 1998
IEC60065: 1998
EMC: EN55103-1: 1997 emission(1)
EN55103-2: 1997 immunity(2)
This device complies with the requirements of the Low Voltage
Directive 73 / 23 / EEC and the EMC Directive 89 /336 / EEC.
This device also complies with EN 55103-1 & -2. Operation is subject
to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
Environmental specications for Meyer Sound electronics products:
Operating Temperature: 0˚C to + 45˚C
Nonoperating Temperature: <-40˚C or > +75˚C
Humidity: to 95% at 35˚C
Operating Altitude: to 4600 m (15,000 ft)
Nonoperating Altitude: to 6300 m (25,000 ft)
Shock: 30g 11 msec half-sine on
each of 6 sides
Vibration: 10 Hz to 55 Hz (0.010 m
peak-to-peak excursion)
© 2003 Meyer Sound. All rights reserved.
M3D and M3D-Sub QuickFly® Rigging Manual
The contents of this manual are furnished for informational purposes only, are subject to change without notice, and should not be construed as a
commitment by Meyer Sound Laboratories Inc. Meyer Sound assumes no responsibility or liability for any errors or inaccuracies that may appear
in this manual.
Except as permitted by applicable copyright law, no part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any
form or by any means, electronic, mechanical, recording or otherwise, without prior written permission from Meyer Sound.
M3D, TruPower, RMS, BroadbandQ, MAPP Online and REM are trademarks of Meyer Sound. Meyer Sound, SIM and QuickFly are registered
trademarks of Meyer Sound (Reg. U.S. Pat. & Tm. Off.). All third-party trademarks mentioned herein are the property of their respective trademark
holders.
Printed in the U.S.A.
Part Number: 05.105.400.01, Rev. B
Ofce of Quality Manager
Berkeley, California USA
July 19, 2002