Filter
Top Products
23
Listen Processor
The C500 Preamplifier has a Listen Processor Loop for
connecting an external sound processor. The Listen Proces-
sor may be assigned to be active for only those Inputs de-
sired. To activate the Listen Proccessor Loop and assign
Inputs, perform the following steps:
Note: If the Listen Processor is set active for a given Input
and no Listen Processor is connected to the C500, no
sound will be heard when that Input is selected.
1. Press the SETUP Push-button twice to access the Setup
Preamp Mode unless the C500C is already in the Setup
Preamp Mode.
2. Rotate the MENU Control until the Alphanumeric Dis-
play indicates “LPROC NONE”. Refer to figure 40.
3. Rotate the SELECT 2 Control until the word
PRESENT appears in the Display, “LPROC
PRESENT”. Refer to figure 41.
4. Rotate the MENU Control until the Alphanumeric Dis-
play indicates “LPROC TUN - -”. Refer to figure 42.
5. Rotate the SELECT 2 Control until the word ON ap-
pears in the Display, “LPROC TUN ON”. Refer to
figure 43.
6. Rotate the SELECT 1 Control until the Title of the next
desired Input is displayed and then set the Listen Pro-
cessor to On.
7. Rotate the SELECT 2 Control until the word ON ap-
pears in right side of the Display.
8. Repeat steps 6 and 7 until all Inputs requiring the Listen
Processor have been set active.
9. If no other adjustments are to be made at this time,
press the SETUP Push-button to exit the Setup Preamp
Mode or proceed to the next desired Setup Preamp
Mode for adjustment.
Figure 40
Figure 41
Figure 42
Figure 43
The C500 Preamplifier has a Record Processor Loop for
connecting an external sound processor. The Record Proces-
sor may be assigned to be active for only those Inputs de-
sired. To activate the Record Proccessor Loop and assign
Inputs perform the following steps:
Note: If the Record Processor is set active for a given Input
and no Record Processor is connected to the C500, no
sound signal output will be available for recording
purposes when that Input is selected.
1. Press the SETUP Push-button twice to access the Setup
Preamp Mode unless the C500C is already in the Setup
Preamp Mode.
2. Rotate the MENU Control until the Alphanumeric Dis-
play indicates “RPROC NONE”. Refer to figure 45.
3. Rotate the SELECT 2 Control until the word
PRESENT appears in the Display, “RPROC
PRESENT”. Refer to figure 46.
4. Rotate the MENU Control until the Alphanumeric Dis-
play indicates “RPROC TUN - -”. Refer to figure
47.
5. Rotate the SELECT 2 Control until the word ON ap-
pears in the Display, “RPROC TUN ON”. Refer to
figure 48.
6. Rotate the SELECT 1 Control until the Title of the next
desired Input is displayed and then set the Record Pro-
cessor to On.
7. Rotate the SELECT 2 Control until the word ON ap-
pears in right side of the Display.
8. Repeat steps 6 and 7 until all Inputs requiring the
Record Processor have been set active.
9. If no other adjustments are to be made at this time,
Record Processor
Figure 45
Figure 46
Figure 47
Figure 48