Filter
Top Products
30
The McIntosh C45 TM1 AM/FM Tuner Module incorpo-
rates an advanced design AM/FM Tuner with many desir-
able performance features to enhance your enjoyment of ra-
dio broadcasts. There are three methods of tuning AM/FM
Broadcast Stations using the Front Panel Tune Push-buttons
and four methods using the Remote Control. These tuning
methods include Manual, Automatic Station Seek, Auto-
matic Preset Review, Preset Selection and Direct Preset
Number Access.
Notes: FM Broadcast Band Indications are in Megahertz in
the US and Canada, and change frequency in 200kHz
steps. For FM stations in various locations other than
the US stations change in 50kHz steps. AM Broadcast
Band Indications are in Kilohertz and change
frequency in 10kHz steps.
1. Select TUNER FM or TUNER AM with the Front
Panel INPUT Control or the Remote Control TUNER
Push-button followed by the AM or FM Push-button.
Refer to figures 42 & 43.
2. For Manual Station Selection, press the Front Panel
TUNE(TRIM LEVEL) Up
SS
SS
S or Down
TT
TT
T Push-button.
3. For Automatic Station Seek, press and release the
CHANNEL Up
SS
SS
S or Down
TT
TT
T Push-button on the Re-
mote Control, to select stations.
Note: The Front Panel TUNE(TRIM LEVEL) Up
SS
SS
S or
Down
TT
TT
T Push-button may also be used, however
the tunning mode in setup needs to be changed to
the SEEK Mode from the default setting of Manual
TUNE. Refer to page 16 for additional
information.
4. For Automatic Preset Review, press and release the RE-
VIEW Push-button on the Remote Control. The C45
will stop on the next assigned Preset Station for
approximatley 5 seconds and then will proceed to the
next Preset Station. When the desired station is heard
press the REVIEW Push-button a second time to cancel
the Preset Review Mode.
How to Operate the Tuner
Note: There first must be stations entered into Preset
Memory for the Review Mode to function. Refer to
“How to Assign Tuner
Presets” for
additional
information.
5. For Preset Selection, press
and release the NEXT
or BACK Push-button
on the Remote Control, to
select a Preset Station.
Note: The Front Panel
TUNE (TRIM
LEVEL) Up
SS
SS
S or
Down
TT
TT
T Push-button
may also be used,
however the tunning
mode in setup needs
to be changed to the
PRESET Mode from
the default setting of
Manual TUNE.
Refer to page 16 for
additional
information.
6. For Direct Preset Number
Access, select the Tuner
AM or FM Input using ei-
ther the Front Panel IN-
PUT Control or press the
TUNER and AM or FM
Push-buttons followed by
the numbered push-button
for the desired Preset.
XX
W
W
Figure 42
Figure 43