Filter
Top Products
64
ENGLISH DEUTSCH FRANÇAIS ITALIANO ESPAÑOL NEDERLANDS SVENSKAENGLISH DEUTSCH FRANÇAIS ITALIANO ESPAÑOL NEDERLANDS SVENSKA
Registering preset codes
n Programming with the 4-digit code
1
Press and hold down the input
source select buttons for the
appliance to control, and press
SET until the SEND indicator
blinks twice.
The back light flashes.
2
Press the 4-digit code for the
appliance using the numeric
buttons (code table at the end of
this book).
When the procedure is successful, the
SEND indicator blinks twice.
NOTE
If the indicator did not blink twice, then repeat
steps 1 and 2 and try entering the same code
again.
n Scanning the code table
1
Switch on the appliance to
control.
2
Press and hold down the input
source select buttons for the
appliance to control, and press
SET until the SEND indicator
blinks twice.
The back light flashes.
3
Aim the remote control at the
appliance and slowly alternate
between pressing INPUT d
and SOURCE ON/OFF for the
appliance.
4
Stop when the appliance turns
off.
5
Press ENTER once to lock in the
code.
n Checking the code
1
Press and hold down the
input source select buttons for
appliance to control, and press
SET until the SEND indicator
blinks twice and back light
ashes.
The back light flashes.
2
Press SEARCH/INFO.
The SEND indicator blinks twice.
3
To view the code for rst digit,
press 1 once.
Count the number of times the SEND
indicator blinks (e.g. 3 blinks = 3) and
write down the number.
4
Then press 2 to check the second
digit of the code. Now press 3 and
4 to check the third and fourth
digits of the code.
NOTE
If a code digit is “0”, the SEND indicator does
not blink.
n Resetting the code
The devices shown below are registered for each input source
button as default. Settings can be changed according to the
devices to be used.
1
Press and hold down the
input source select buttons for
appliance to control and press
SET until the SEND indicator
blinks twice.
The back light flashes.
2
Press the codes below to reset the
code.
The indicator will blink twice.
Input source select
buttons
Category Preset code
Blu-ray Disc player 5000
DVD player 2000
Television 1000
Satellite set top box 4000
CD player 3000
NOTE
After this procedure, the selected source reset to its initial code.