Filter
Top Products
7
Flush Mount Above-Deck Installation
This installation differs from the Flush Mount through-deck Installation in that the
cable is routed out of the back of the LWX-1 Antenna, instead of through the deck.
To use Flush Mount above-deck installation:
With a pair of needle-nose pliers break away/remove the channel 1.
stop, so the interconnect cable can t ush in the cable channel on
the bottom of the LWX-1.
Insert the RJ45 interconnect cable into the cable channel.2.
Ensure the rubber boot on the Interconnect Cable is rmly in the AR 3.
Rubber Boot Inset so it is ush with the
bottom of the LWX-1 Base.
Use the mast pound panel to mark 4.
where the machine screws will be
drilled. Drill 1/32” starter holes.
Make sure the interconnect cable is 5.
secured in the cable channel and then
mount the LWX-1 to the deck using the
four supplied machine screws.
Use the four white screw caps to cover the bolt holes on top of the 6.
LWX-1 cover.
Breaking away the channel stop.
Insert rubber boot into boot inset.
Boot inset
Channel
Stop
Rubber
boot