Filter
Top Products
5
Mast Mount Installation
The LWX-1 Antenna Receiver (AR) is shipped pre-congured for a mast mount.
To use LWX-1 Mast Mount Installation:
Loosen the four LWX-1 AR Bolts & Nuts. The circular mast boot on 1.
the bottom of the LWX-1 will loosen, allowing it to turn.
Insert the RJ45 Interconnect Cable into the mast/pole mount and 2.
route it to the Interface Module.
Move the LWX-1 antenna into the desired position and screw the 3.
mast boot onto the mast/pole. The
LWX-1 mast mount is designed for
occasional hand alignment, so hand-
tighten as much as possible – DO NOT
OVER-TIGHTEN.
With the LWX-1 installed, move it in to 4.
the desired position and re-tighten the
four AR Bolt & Nuts.
Use the four white screw caps to cover the bolt holes on top of the 5.
LWX-1 cover .
Hand tighten LWX-1 onto
mast mount.
Loosening LWX-1 AR Bolts. Insert RJ45 Interconnect Cable into
mast/pole mount.