Filter
Top Products
8
Interface Module Installation
We recommend the Interface Module be mounted below
deck in a water tight area.
To install the Interface Module:
Open the inteface module by unscrewing 1.
the two interface module housing screws
on the top of the module.
Insert the RJ45 cable connector into the interface module RJ45 2.
connector inside the module housing. The RJ45 connector will
click into place when it is connected correctly.
Route the AR Interconnect 3.
Cable through the exit slot
of the module (between
the other two cables) and
close the module.
Tighten the inferface 4.
module housing screws.
Mount the module on a 5.
vertical surface using the
supplied mounting screws.
Make sure the cables exit
downward.
Connect the interface module Power Cable to the vessel’s power (8 6.
to 16 VDC source).
Connect the module’s ethernet connector directly to your HDS unit 7.
or Navico Expansion Port (NEP).
RJ45 connector