Lowrance electronic LVR-250 Radio User Manual


 
Lowrance - LVR-250 Installation and Operation Instructions 9
that will be covered by the radio fascia after installation.) Drill the 4 mounting holes.
Remove the installation template and slide the radio into the cavity.3.
Screw each M5x32 screw through the screw hole in the mounting bracket, then attach 4.
the stopper. If your bulkhead exceeds 0.51” (13mm), the stopper can be discarded if
necessary.
Tighten the M5x32 screws until the radio is held firmly against the rear of the bulkhead.
5.
Install the Microphone Bulkhead Mount
Hold the microphone bulkhead mount at the 1.
chosen location and use a soft pencil to mark
the screw hole positions on the mounting
surface. Ensure that the microphone curly cable will
comfortably reach this location BEFORE you drill.
Drill the two pilot screw holes where marked.
2.
Use a short length Philips screwdriver and the 3.
set of two flat screws, spring washers, plain
washers, and nuts to secure the microphone
bulkhead mount at the location site.
Hang the microphone on its mount.
4.
MM
MM
MM
 M
