Logitech DLA2RF Speaker System User Manual


 
14 ©2007 • All rights reserved.
DLA2RF 2 Room Speaker Selector
4. Settings & Operation
Functions of the DLA2RF may be controlled from the Front Panel, or the included RF Remote.
Volume Settings
Receiver/Amplifi er Volume Settings
Prior to setting volume levels of the DLA2RF, proper volume level must be set at the Receiver/
Amplifi er. To set proper Receiver/Amplifi er volume level:
Turn on the Receiver/Amplifi er and start an audio source (CD Player, Radio, etc.).
Adjust the Receiver/Amplifi er level to the lowest setting.
Set the Receiver/Amplifi er to Stereo and disable any surround sound or DSP
modes or “Sound Fields”.
If using a Receiver/Amplifi er with “A/B” speaker outputs, select the “B” speak-
ers and turn off the “A” speakers for maximum output to the DLA2RF.
Note: When the DLA2RF is not in use, turn off the “B” speakers
and turn on the “A” speakers for normal operation.
Turn on one room of the DLA2RF and adjust the volume level to maximum.
While listening to the room turned on in the previous step, slowly adjust the Re-
ceiver/Amplifi er volume to the loudest level possible without distortion. Make a
note of the receiver/amplifi er level for future reference.
RECEIVER/AMPLIFIER LEVEL
Turn on each room of the system and adjust the volume of the DLA2RF to a com-
fortable level.
Volume Status Bar
The front panel includes a Volume Indicator LED bar with 11 LED’s located above the All On/Off
and Volume -/+ buttons. The Volume Indicator LEDs display the Volume for whichever Room is
selected. When a Room is selected and NO LEDs are lit, that room is at minimum volume. When
a Room is selected and ALL LEDs are lit, that room is at maximum volume.
Volume Status Bar
Figure 4-1: Volume Status Bar
1.
2.
3.
4.
5.
6.
7.