Filter
Top Products
© 2007 • All rights reserved. 11
DLA2RF 2 Room Speaker Selector
3. Connections
AMPLIFIER INPUT
Use 16 AWG stranded copper speaker wire to connect from a speaker level output of an A/V
receiver, stereo receiver, or amplifer. Turn power for the output device OFF before making con-
nections.
To make connections:
Cut the ends of the wire to length, allowing some free play (about 6 inches
of slack) to allow for movement when physically connecting the wire.
Using wire strippers, remove 3/8 inch of insulation, then twist the wire to
ensure that no stray strands are evident.
Defi ne positive (+) and negative (-) at the amplifi er end and the DLA2RF
end of the wire run and use the same conductor on each end.
Lift up each fl ip-lock connector until it is locked in the up position.
Place the bare lead from each speaker wire from the receiver/amplifi er
into the holes of the Amplifi er Inputs terminal of the DLA2RF, maintaining
the polarity of each lead (+ to +, - to -).
Note: To avoid damage to the receiver/amplifi er, DO NOT allow speaker leads to touch
each other.
CLASS 2 WIRING
AMPLIFIER
INPUT
Speaker
Cables
Receiver/Amplifier
Output
DLA2RF
+
-
L
L
R
R
B
A
Figure 3-1: Receiver/Amplifi er Output to DLA2RF Amplifi er Input
1.
2.
3.
4.
5.
125 Watts
per Channel
Max