Filter
Top Products
24 MT2000-0200-01 Rev f (10-2007)
DCN0160
END (CFG MENU)
RNG - Range
LTP - Low Trim Point
HTP - High Trim Point
LTC - Low Trim counts
HTC - High Trim counts
TMP - Module Temperature
SOR - Signal Out of Range
LRM - Low Range Margin
LRS - Low Range mA
SAT
END
LL1 - Liquid Level 1
(Main Menu)
Select
UP/DOWN
Arrow
Configuration 2 (Hidden) Menu
The sensor trim is now complete and the LRV has been set to equal 0 and URV has been set to the value of HTP. If
other LRV and URV are desired, then proceed to the CAL menu and change LRV and URV accordingly.
If the level cannot be moved, the transmitter must be removed for re-trimming. Please contact the factory before
trimming to confirm the procedure to follow. Should the trim be suspected of being corrupted, please consult the fac-
tory. The transmitter can be brought back to the factory calibration conditions by performing a “3 Button Reset”.
This is accomplished by simultaneously pressing “UP”, “DOWN” and “SELECT”. This action is generally recom-
mended as a “last resort” prior to returning the transmitter to the factory for analysis, repair (if needed) and re-
calibration.
Figure 9.2
SAT
ALRM
9.2 APPENDIX B: Additional Special Functions in the CFG2 (Hidden) Menu
These functions are accessed by pressing the ‘UP’ and ‘DOWN’ buttons together, when the LCD display is on
‘END’ at the end of the CFG menu. Enter the Sensor Trim menu and scroll down to access the following func-
tions: