Filter
Top Products
OPERATION
OPERATING INSTRUCTIONS
1. Select an input with the Input switch. Notice the Signal LED
will illuminate when the digital ~ource is turned on and has linked
with the Processor. Once this link is complete, the Processor is
ready to pass a signal. If you are utilizing the TimeSync interlink,
press the TimeSync button at this time. The TimeSync LED will
illuminate.
2. Be sure that your preamplifier’s volume control is turned
completely to the OFF (lowest volume) position.
3. Turn ON your components, remembering that the last compo-
nent to be energized should be your amplifier. The amplifier
should only be turned ON after all other components in the
system have been on for at least two minutes. This will insure that
there will not be any large pulse created when the amplifier is
turned on.
4. Switch the source selector of your preamp to the position
correlating to your chosen input connection for the
REFERENCE 64.
5. You may now start playing your digital source, DAT, CD or
satellite.
6. Slowly turn the volume control up to the lowest level you can
hear. Check to see that both channels are working correctly
before advancing the volume.
PAGE 21