Filter
Top Products
CONNECTIONS -
TAPE MONITOR INPUTS AND OUTPUTS
1 Digital only tape output: Intended for CD-R or DAT
2 Digital monitor inputs using auto selection system
1 AT&T normally active, priority over coax input
1 coax selected by default system
The digital signal at the tape output is the active digital input
signal selected. The use of external clock or TimeSync feature
does not interfere with the output of the selected digital signal to
the tape output RCA.
The digital TAPE MONITOR input allows either an AT&T input or
a coax input. The AT&T is the active input if there is digital data
present at the AT&T receiver. If no data is present at the AT&T
receiver, the internal default logic automatically selects the coax
input. ~
The use of the MONITOR button on the front panel selects the
TAPE IN inputs on the rear panel. The use of this input does not
interfere with the input selection being sent to the Digital tape
output.
NOTE: The Tape input can also be used as an additional source
input, without use of the digital record output. This input signal
cannot appear at the digital tape output jack.
CAUTION: The Tape output is a digital signal and can not be used
as an analog output to drive front end components such as a
preamplifier or cassette recorder.,
NOTE: The selected digital input is always routed to the tape
output regardless of the SOURCE/MONITOR button position.
PAGE 14