Filter
Top Products
CONNECTIONS
The operation of the Processor utilizing the TimeSync feature
requires that the data input be selected first and then the
be selected. The TimeSync and the DATA
TimeSync input
input
selected must be from the same source. If the DATA and TimeSync
are from different sources the processor will, after a very short
period, go into a MUTE mode. The MUTE mode can be cleared by
pressing the TimeSync button again, reselecting a DATA input,
and then optionally selecting the TimeSync if this input is
connected to the same data source.
NOTE: The use of the TimeSync feature does eliminate the jitter
normally encountered in the normal decoding of the digital data
stream; however, the proprietary Krell DATA RECOVERY AND
JITTER RF_~ECTION MODULE reduces jitter to an almost
unmeasurable level. TimeSync provides an additional level of
Jitter reduction.
NOTE: The use of the TimeSync button without having an actual
TimeSync input or a mismatched input( different input selected
than the input from which the TimeSync signal originates) will
cause the processor to go into MUTE mode. The TimeSync input
select LED will flash when the mismatch condition or no input is
present. The frequency indicator LED will still indicate the input
frequency of the selected input.
NOTE: The TimeSync system is connected with an AT&T ST type
fiber optic cable.
PAGE 17