Filter
Top Products
CONNECTIONS
3. The Left and Right channel RCA outputs are labeled on the
back panel. The balanced outputs are not labeled. The balanced
connector closest to the Left RCA output is the left channel output
and the connector closest to the RCA right output is the right
balanced output. Care should be taken to insure that the channel
orientation between the Processor and the high level inputs of
your preamplifier is maintained.
4. Connect the digital output of your CD transport and other
digital sources to the inputs of the REFERENCE 64. If you are
using multiple digital sources, take note of where each input and
corresponding switch setting is located.
The REFERENCE 64 is equipped with the following inputs: two
coaxial, one AT&T wide bandwidth fiber optic, one TOSH fiber
optic, and one AES/EBU. All inputs can accept a signal from any
digital source such as Compact Disc players, Laser Disc players,
DATs or satellite receivers. The REFERENCE 64 is also equipped
with a single AT&T and single coax digital tape return input.
When a powered digital source is introduced to an input and that
input is selected with the specific Input switch, the corresponding
signal LED will illuminate.
5. Once you have completed the necessary input and output
connections, select the input of your choice. For each input
selected, the corresponding LED will illuminate to indicate which
input is active (or has been selected). You will know if the input
selected is active by observing if one of the frequency input LEDs
is illuminated. If a CD transport is selected the 44.1 KHz LED will
be lit.
NOTE: If the digital source is ON~d one of the frequency LEDs
does not illuminate, check to make sure the digital interconnect
cable is secure at both ends or is not in need of repair. Make sure
the component supplying the digital source is active.
PAGE 12