Filter
Top Products
50
Troubleshooting System Noise
When you mix and match high-performance audio components, each with its own
ground potential, a low frequency hum may occur in one or both loudspeakers.
If this happens when you place the Evolution Two preamplifier into your system,
follow these simple troubleshooting steps.
1. Check that all input and output connections are of sound construction.
2. With the preamplifier channel off, remove the interconnect cables, the turn the
preamplifier channel on. If the hum disappears, turn the preamplifier channel
off and reinsert one of the interconnect cables. Turn the preamplifier channel
back on. Repeat this process for each cable.
3. If the hum reappears with one or both interconnect cables reinserted, the cable
needs to be replaced.
4. If the interconnect cables are sound, you may be experiencing a ground loop.
Please contact your authorized Krell dealer, distributor, or Krell for suggestions
on how to eliminate the ground loop.
(SECTION EIGHT: Questions and Answers continued)