Filter
Top Products
FORCE RIGHT
Use to make a right channel respond as a left channel.
FORCE NONE
The preamplifier channel ignores balance selections. Use this option to set up
more than 2 preamplifier channels.
NO OVERRIDE
Return to CHANNEL ASSIGN. Serves the same function as BACK in all other menu
items.
For more information on linked preamplifiers, see Appendix: CAN Link and
Multiple Evolution Two Preamplifiers,
on page 51.
Clone
This function enables you to transfer configured functions between linked pream-
plifier channels. There is no need to configure multiple menu choices for each pre-
amplifier channel. Clone insures that, where desired, the configuration of functions
for multiple preamplifier channels is identical. The option is:
CLONE BEGIN.
Enter the menu, then:
1. Identify the clone transmitter and clone receiver. The clone transmitter is the
preamplifier channel that transmits the clone and the clone receiver(s) is/are
the preamplifier channel(s) that receive(s) the clone.
2. Use the level control knob on the preamplifier chassis front panel (1) of the
clone transmitter, or the up and down keys (16) on the remote control to select:
CLONE.
3. Pr
ess the enter button on the preamplifier chassis front panel (1) of the clone
transmitter or the enter key (18) on the remote control
. The front panel display
(15) r
eads:
CLONE BEGIN.
4. Pr
ess the enter button or the enter key again
. The clone transmitter display
reads:
CLONE TRANSMIT and the clone receiver display(s) read(s): CLONE RECEIVE.
5. Pr
ess the enter button on the fr
ont panel of the clone transmitter
. All clone
r
eceivers go into stand-by mode, indicating that the clone is accomplished.
Note
The enter button on the r
emote contr
ol cannot be used to activate the clone function.
continue
d
35