Krell Industries EVOLUTION TWO MONAURAL PREAMPLIFIER Stereo Amplifier User Manual


 
37
continue
d
ON
The front panel display is always on.
TIMED
The front panel display times out after 5 seconds.
BRIGHTNESS
Controls the brightness of the display. When the brightness setting is OFF, the
display is at 50% of brightness when in menu mode, and turns completely off
when you leave the menu mode.
Info
This function enables you to access information about the preamplifier software,
EEPROM, and PC Boards. The PC Boards are listed in the left margin, on this
page.
Enter the menu, then:
1. Use the level control knob on the preamplifier chassis front panel or up and
down keys (16) on the remote control to select:
INFO.
2. Press the enter button on the preamplifier chassis front panel or the enter key
(18) on the remote control
. The front panel display (15) show the software ver-
sion number.
3. Rotate the level control knob clockwise or press the up key. The front panel
display shows the EEPROM version number.
4. Rotate the level control knob clockwise or press the up key again. The front
panel display shows the PC
board version number.
5. Press the enter button or key. Use the level control knob or the up and down
keys to scroll through the version numbers of PC boards, from the PC Boards
listed at left.
EEPROM
Electrically erasable programmable read-only memory. An erasable memory chip
used in the Evolution Two to store menu selection information.
PC Boards
CAST IN 1
CAST IN 2
CAST IN 3
CONNECT
CONTROL
DISPLAY
DISPLAY VERSION
ENCODER
FACEPLATE
MAIN
OUT 1
OUT 2
REGULATOR
T
APE OUT 1
TAPE OUT 2
VOLT IN
VOLUME