Filter
Top Products
61
15 CONNECTING PERIPHERAL EQUIPMENT
RTTY EQUIPMENT
Use the ACC 2 connector to connect to the RTTY equipment. Connect the RTTY key output line to pin 2 of the ACC 2
connector. Connect the demodulation input line of the RTTY equipment to pin 3 of the ACC 2 connector.
Note:
Do not share a single power supply between the transceiver and the RTTY equipment. Keep as wide a separation as possible between the
transceiver and the RTTY equipment as practical to reduce noise-pickup by the transceiver.
LINEAR AMPLIFIER
Connect an external transmit power amplifier to the REMOTE connector. Before using the external amplifier, switch
ON the linear amplifier control relay via Menu No. 39.
The TX/RX relay response time is 10 ms when you have selected CW Full Break-in and 25 ms when you have
selected CW Semi Break-in.
Note:
The TX/RX control method differs depending on external amplifier models. Some amplifiers enter the TX mode when the control terminal is
grounded. For those amplifiers, connect pin 2 of the
REMOTE
connector to the GND terminal of the amplifier and connect pin 4 of the connector to
the control terminal of the amplifier.
ANTENNA TUNER
Use the ANT 1 connector and the AT connector to connect an external antenna tuner. If you connect the external tuner
to the ANT 2 connector, the external tuner will not function.
Note:
While using an external antenna tuner with the TS-570S, you cannot use the 6 m band to transmit. Connect your 6 m band antenna to the
ANT 2
connector.
Speaker output
Common terminal
Standby; when grounded, the
transceiver enters TX mode.
When connected with the common
terminal, the amplifier enters TX mode.
When connected with the common
terminal, the amplifier enters RX mode.
1
2
3
4
5
ALC input from amplifier
Approx. +12 V DC is output when in
TX mode (10 mA max.).
6
7
Pin
No.
Function
REMOTE connector
MCP
power
supply
TS-570
ACC 2
MCP
Personal computer/
dumb terminal
TS-570
External antenna tuner
2
4
1
67
3
5
TS-570
AC LINE
RF OUTPUT
Linear
amplifier
Control relay
R
T
GND
REMOTE Connector
(Rear panel view)