Filter
Top Products
MEMORY CH-3
NAMING A MEMORY CHANNEL
You can name Memory channels using up to 8 characters. When
you recall a named Memory channel, its name appears on the
display. Names can be callsigns, repeater names, cities, people,
etc.
1 Press [MR] to enter Memory Recall mode.
2 Rotate the Tuning control to select your desired Memory
channel.
3 Enter Menu mode and access Menu 200.
4 Enter your desired name for the channel.
Note: You can overwrite a Memory channel name by performing the steps
above. You can also clear a Memory channel name by clearing the Memory
channel.
MEMORY-TO-VFO TRANSFER
Transferring the contents of a Memory channel or the Call
channel to the VFO can be useful if you want to search for other
stations or a clear frequency, near the selected Memory channel
or Call channel frequency.
1 Press [MR] or [CALL] to enter Memory Recall mode or select
the Call channel.
2 Rotate the Tuning control to select your desired channel.
(This step is not necessary when selecting the Call channel.)
3 Press [F], [M>V].
• The entire contents of the Memory channel or Call channel are
copied to the VFO, and VFO mode is selected after the transfer is
complete.
• When copying a transmit frequency from an odd-split Memory or
Call channel, you must fi rst turn the Reverse function ON before
pressing [F], [M>V].
CHANNEL DISPLAY FUNCTION
Use this function when you want to use only Memory channels.
When this function is switched ON, the transceiver displays only
a Memory channel number instead of a frequency.
1 Turn the transceiver power OFF.
2 Press [LOW] + Power ON to turn the channel display ON or
OFF.
Note:
◆ If no Memory channels have saved data in them, channel display will not
function.
◆ When using Channel Display, you cannot reset the transceiver.
While in Channel Display mode, the transceiver keys function as
shown next page: