Filter
Top Products
MEMORY CH-2
STORING ODD-SPLIT REPEATER FREQUENCIES
Some repeaters use a receive and transmit frequency pair
with a non-standard offset. To access those repeaters, store
two separate frequencies in a memory channel. You can then
operate on those repeaters without changing the offset frequency
you stored in the menu.
1 Set up a simplex channel by following steps 1 to 6 of
“STORING SIMPLEX AND STANDARD REPEATER
FREQUENCIES”, above.
2 Press [VFO] to enter VFO mode.
3 Rotate the Tuning control to select your desired transmit
frequency.
• Additionally, you can press the microphone [UP]/[DWN] keys to
select a frequency.
4 Set up any additional data desired for the transmit frequency.
• Tone ON/OFF, Tone frequency, CTCSS ON/OFF, CTCSS
frequency, DCS ON/OFF, DCS code, etc.
5 Press [F].
• A memory channel number appears.
6 Rotate the Tuning control to select your desired channel
number.
• Additionally, you can press the microphone [UP]/[DWN] keys to
select a channel.
7 Press [PTT], [M.IN] to store the data in the selected Memory
channel.
■ Call Channel Memory (Odd-Split)
The Call channel can be used to store any frequency and
related data that you will recall often. You may want to
dedicate the Call channel as an emergency channel within
your group.
To store an odd-split frequency and related data as the Call
channel instead of in a Memory channel, after step 6 (above),
press [PTT], [C.IN].
Note:
◆ You cannot set the transmission and reception frequencies on different
bands.
◆ You cannot set a different frequency step size for the transmission and
reception frequencies.
◆ You cannot store the transmit offset status and Reverse status in an odd-
split Call channel.
RECALLING A MEMORY CHANNEL
1 Press [MR] to enter Memory Recall mode.
2 Rotate the Tuning control to select your desired Memory
channel.
• Additionally, you can press the microphone [UP]/[DWN] keys to
select a channel, or you can enter a channel number using the
microphone keypad.
■ Memory Recall Method
The transceiver Menu also provides you with the option to
recall Memory channels with stored frequencies in your
current band, or all Memory channels:
1 Enter Menu mode and access Menu 201.
2 Set the recall method to CURRENT (current band) or ALL
BANDS (all bands).
• CURRENT allows you to recall only those memory channels
that have stored frequencies within the current band. ALL
allows you to recall all programmed memory channels.
• When the recalled memory channel is an AM channel, you
cannot recall on the B band.
Frequency ranges:
• 118 MHz: 118 ~ 135.995 MHz
• 144 MHz: 136 ~ 199.995 MHz
• 220 MHz: 200 ~ 299.995 MHz
• 300 MHz: 300 ~ 399.995 MHz
• 430/440 MHz: 400 ~ 523.995 MHz
• 1200 MHz: 800 ~ 1299.990 MHz
CLEARING A MEMORY CHANNEL
1 Press [MR] to enter Memory Recall mode.
2 Rotate the Tuning control to select your desired Memory
channel.
• Additionally, you can press the microphone [UP]/[DWN] keys to
select a channel, or you can enter a channel number using the
microphone keypad.
3 Turn the transceiver power OFF.
4 Press [MR] + Power ON.
• A confi rmation message appears on the display.
5 Press the Tuning control to clear the Memory channel.
• To exit without clearing the channel, press [ESC].