Filter
Top Products
40
incoming cAll notificAtion type
Note: To use Incoming Call Notication, you must set up a QT tone
or a DQT code {page 16}.
Incoming Call Notication is used to inform you of when a call
is being received. When activated, a tone is emitted when a
busy signal is received and the QT/ DQT signalling matches.
• The tone will sound for 15 seconds before turning off.
• While the tone sounds, you will not hear any audio from the
speaker. Press any key to turn the tone off and listen to the
received call.
After the call is nished, the transceiver will wait for 10 seconds
before resetting. If you receive a new call within those 10
seconds, the tone will not sound. If no call is received within
10 seconds, Incoming Call Notication will reset so that the
next time a call is received, the tone will sound again.
To turn Incoming Call Notication on or off:
1 With the transceiver power OFF, press and hold the MENU
key while turning the transceiver power ON (for 1 second).
2 Press the or key to select “Ct”.
3 Press the MENU key then press or to select “Ct-oF”
(incoming call notication off), or “Ct-on” (incoming call
notication on).
4 Press the MENU key to conrm the selection.
5 Press the PTT, MON, or CAL key to exit Setting Mode.