Filter
Top Products
22
• While adjusting the VOX Delay Time, speak into the
microphone to simulate transmitting. The LED lights orange
while speaking, but no signal is transmitted at this time.
4 Press the MENU key to conrm the selection.
5 Press the PTT, MON, or CAL key to exit Setting Mode.
voX trAnSmit inhiBit
While using VOX, you can set the transceiver to detect when
the channel is in use (in place of using the Monitor function).
With this function turned on, VOX will not allow you to transmit
while the channel is being used. You can transmit only when
the channel is free. Setting up the proceed tone function
{page 23} will notify you when the channel is free.
1 With the transceiver power OFF, press and hold the MENU
key while turning the transceiver power ON (for 1 second).
2 Press the or key to select “tI”.
3 Press the MENU key then press or to select “tI-on”
(transmit inhibit on) or “tI-oF” (transmit inhibit off).
4 Press the MENU key to conrm the selection.
5 Press the PTT, MON, or CAL key to exit Setting Mode.