Filter
Top Products
28
SelcAll (Selective cAlling)
A Selcall is a voice call to a particular station or group of
stations. Each transceiver is set up with an individual ID
number for use with selcalls.
■ mAking A SelcAll
1 Press the CAL key.
2 Press the or key to select an ID number.
• “Id” represents a single station, “GP” represents a group of
stations, and “AL” represents all stations.
3 Press the PTT switch to transmit the selected selcall ID.
• The transceiver waits for the Data Transmit Modulation
Delay time {page 29} before transmitting the selcall ID.
• The side tone sounds if PTT ID side tone {page 30} is
enabled.
4 Release the PTT switch, then continue the call as
normal when you receive a response.
5 Press the CAL key to end the call.
Note: If Optional Signalling (menu “oP”) has been set to “FS”
(FleetSync), you can also set up an Individual Selcall Alert
type (menu “IA”) and Group Selcall Alert type (menu “GA”).
Individual and Group Selcall Alert types range from “-oF” (off)
and “- 1” (type 1) to “-10” (type 10). Refer to the menu list on
page 45.