Filter
Top Products
Receiver Setup
Chapter Three : Using Receiver’s Front Panel to Set Up the Speakers and Radio Stations
49
Storing Radio Stations in Memory
(optional)
Radio stations can be preset in the memory in the receiver
and recalled by a one-touch operation.
The memory in the receiver cannot store the station names.
To store the station names, use PowerTouch III. (For details,
see “Storing Radio Stations in Memory (optional)” on page
41.)
Storing RDS Stations Automatically:
1. Press the INPUT SELECTOR (¤ or ‹ ) button to se-
lect the Tuner input.
2. Press the BAND button to select the FM band.
3. Press and hold the MEMORY button for more than 2
seconds. The receiver locates and stores any FM stations
broadcasting an RDS signal. This process can take a few
minutes to complete. While the receiver is searching, the
display blinks “AUTO MEMORY”.
H. Press either MULTI CONTROL (fi/%) button. You
will hear the bass peak test tone, and the display will
read -30dB. (The test tone level is not affected by the
receiver’s volume control.)
I. Press the MULTI CONTROL (%) button slowly and
repeatedly to increase the speaker volume until you
just begin to hear audible distress from the woofer
(distortion, clicking, “bottoming”).
J. Press the MULTI CONTROL (fi) button once or twice
to decrease the speaker volume to the level just be-
fore the distress began.
K. Press the SET UP button to save the setting and pro-
ceed to “Setting the speaker distances” below.
9. Setting the speaker distances
Measure the distance between each speaker and the lis-
tening position you frequently use. See page 38 for de-
tails.
A. After step K in procedure 8 above, the speaker dis-
tance setting display appears.
B. When “L 3.0m/10ft” is displayed, correct the dis-
tance of the front left speaker from you using the
MULTI CONTROL (fi/%) button.
C. Press the SET UP button to display “C 3.0m/10ft”
and correct the distance of the center speaker from
you using the MULTI CONTROL (fi/%) button.
D. Similarly, set the distances of the “R” (front right),
“SR” (surround right), “SBR” (surround back right),
“SBL” (surround back left), “SL” (surround left) and
“SW” (Subwoofer) speakers.
E. Press the SET UP button repeatedly until “SETUP
FIXED” is displayed.
Storing Stations Manually:
1. Press the INPUT SELECTOR (¤ or ‹) button to se-
lect the Tuner input.
2. Press the BAND button to choose the receiving band.
3. Press the AUTO button to select AUTO TUNING or
MANUAL TUNING.
4. Press the MULTI CONTROL (fi/%) button to tune the
station you want to store.
5. Press the MEMORY button.
6. Press the P.CALL (fi/%) button to display the desired
preset number.
7. Press the MEMORY button again to store the stations as
that preset.
8. To preset other stations, repeat steps 2 to 7 for each
station you want to store.