Filter
Top Products
Chapter Two : Setting Up PowerTouch III
41
Remote Setup
Storing Radio Stations in Memory (optional)
Your new PowerTouch III provides two ways to store radio
stations:
• Manual Memory, which allows you to enter and store
specific stations.
• RDS Automatic Memory, which searches for stations
broadcasting an RDS signal and automatically stores
them in the first available storage button.
There are 40 preset storage buttons available.
Search for and store RDS stations first, then set stations
manually. The search function automatically assigns RDS
stations to the first storage button, overwriting any stations
already stored there.
You can overwrite RDS stations with manually stored sta-
tions.
Storing RDS Stations Automatically
1. Touch (HOME1) on the Quick Access menu to ac-
cess the HOME1 menu:
2. Touch on the HOME1 menu to access the Tuner
controls:
3. Touch to choose FM.
4. Touch
.
5. Touch . The receiver locates and stores any FM sta-
tions broadcasting an RDS signal. This process can take
a few minutes to complete; please be patient. While the
receiver is searching, “AUTO MEMORY” display blinks.
RDS stations are stored in the order they are found, up to
40 stations. If the search finds fewer than 40 stations, the
receiver may automatically store other FM stations in the
open storage buttons.
If you are repeating the RDS search, any existing preset sta-
tions (whether automatically or manually stored) will be
replaced by the results of the new search.
Storing RDS Station Name (PS Read)
• To perform PS Read, you must first perform the RDS
auto memory procedure.
1. Touch
(HOME1) on the Quick Access menu to ac-
cess the HOME1 menu:
2. Touch on the HOME1 menu to access the Tuner
controls: