Kenwood 600 Stereo System User Manual


 
10
Preparation section
The space between radio channels has been set to the one
that prevails in the area to which the system is shipped.
However, if the current channel space setting does not
match the setting in the area where the system is to be used,
for instance when you move from area 1 or area 2 shown in
the following table or vice versa, proper reception of AM/FM
broadcasts cannot be expected. In this case, change the
channel space setting in accordance with your area by refer-
ring to the following table.
CHANNEL SPACE setting
(Except for the U.S.A., Canada, U.K., Europe and Australia)
CHANNEL
SPACE freq.
Area
1
2
USA, Canada and South
American countries
Other countries
FM : 100 kHz
AM: 10 kHz
FM : 50 kHz
AM: 9 kHz
CURSOR
SET
STOP
1
Attach the remote control
unit to the main unit
@
2
Switching the power ON
3
Select the TUNER input.
4
Press and hold the STOP (
7
)
key for about 2 seconds.
5
Select the message to be
displayed, "FM 100kHz" or
"FM 50kHz".
STANDBY/TIMER
ON/STANDBY
CURSOR
SET
TV
VIDEO1
VIDEO2
CD
TUNER
TAPE
FUNCTION
7
INPUT
÷ The setting is remembered even when the power is
switched off.